⚡Megatron LLM Hub
←Back to search
Twitter

Etherbulb:把 ESP32-C3 智能灯泡改成只收 SDR,可视化周围无线电

十几美元硬件即可被动监听 Wi-Fi/Zigbee 频谱,适合无线侧侦察。
工具固件无线
RT @Ready4Sushi: Etherbulb beta release for the ESP32-C3 E27 LED bulb and the SP530 RGB LED controller. Your room is full of radio you never see: Wi-Fi, a phone talking to its earbuds, a smart plug on Zigbee, the cell tower down the road, an FPV drone in the park. Etherbulb turns a 15-dollar smart bulb into a lamp that shows you the air. What it does • Uses the ESP32-C3's Wi-Fi radio as a receive-only SDR (the ESP-SDR path found by ESPARGOS): 80 MS/s I/Q, 25 snapshots a second, 256-point FFT on the chip itself • Hears 2.13–2.73 GHz: all Wi-Fi channels, Bluetooth, Zigbee/Thread, analog FPV video, LTE/5G Band 1, 7 and 38 • Classifies signals by shape* (early alpha) • Blue for Bluetooth, green for Wi-Fi, any colour you pick for anything else. Stronger signal, brighter light • Colour matrix in the dashboard: one row per signal, click a colour, set brightness and sensitivity, or drag a range on the live waterfall to make your own rule • 26 presets from ExpressLRS to microwave ovens, plus 412 mobile-network blocks for 39 European countries, uplink and downlink • Web dashboard served by the bulb: live waterfall, spectrum, log with router time, light and dark theme, works on a phone • Wi-Fi and listening at the same time: the bulb stays on your network while it listens • Idle light: a faint glow until its signal shows up • Switch it off and on 3× for 30 min of Wi-Fi, 7× for a rescue network with the update page. After three crashes it boots the previous firmware by itself LED strips too The same firmware runs on the BTF SP530E strip controller (also ESP32-C3): five outputs, five strips, one per signal type, all on at once. One LED per MHz if you like. Hardware •12 W RGBCW E27 bulb, ESP32-C3 inside. Flashes over Wi-Fi, no screwdriver • SP530E: first flash over UART, Open source, GPL-3.0Your Wi-Fi password stays on the bulb. https://t.co/5MMGCcGDl8 #ESP32 #SDR #smarthome #opensource #RF #maker